2010 Cadillac CTS Owner's Manual - Page 16

1-10 Keys, Doors and Windows The procedure requires three, ten minute cycles to complete the matching process. 1. The vehicle must be off. 3. Insert the vehicle key into the key lock cylinder located on the driver door. 4. Turn the key to the unlock position five times within five seconds. 5. The DIC displays Press Start Control To Learn Keys. 6. Press the ignition switch in. 7. The DIC reads Learn Delay Active Wait XX Min and counts down to zero. 8. The DIC displays Press Start Control To Learn Keys again. 2. Place the new transmitter into the transmitter pocket with the buttons facing the front of the vehicle. The transmitter pocket is inside the center console storage area located between the driver and front passenger seats. 9. Press the ignition switch in again. 10. Repeat Steps 7, 8 and 9. 11. The DIC reads Learn Delay Active Wait XX Min and counts down to zero. 12. A beep sounds and the DIC reads Ready To Learn Electronic Key # X. All previously known transmitter programming has been erased. 8. Press the ignition control knob to exit programming mode. 9. Remove the transmitter from the transmitter pocket and press K on the keyless access transmitter two times. 10. To program additional transmitters, repeat Steps 6 through 9. Programming without a Recognized Transmitter United States owners are permitted to program a new transmitter to their vehicle when a recognized transmitter is not available. The Canadian immobilizer standard requires that Canadian owners see their dealer/retailer for programming new transmitters when two recognized transmitters are not available.