2010 Cadillac CTS Owner's Manual - Page 166

4-56 Instruments and Controls Keyless Unlock If the vehicle has the keyless access system, this feature allows you to select which doors will automatically unlock when you approach the vehicle with the keyless access transmitter and open the driver's door. See the Keyless Access information for Remote Keyless Entry (RKE) System Operation (Key Access) on page 1‑5 or Remote Keyless Entry (RKE) System Operation (Keyless Access) on page 1‑7 for more information. To select whether the lights flash when the vehicle is unlocked, see "Remote Door Unlock" earlier in this section. Press the customization button until Keyless Unlock appears on the DIC display. Press the set/reset button once to access the settings for this feature. Then press the menu up/down button to scroll through the following settings: Entry Door Only: Only the driver's door will automatically unlock when you approach the vehicle with the keyless access transmitter and open the driver's door. All Doors (default): All doors will automatically unlock when you approach the vehicle with the keyless access transmitter and open the driver's door. No Change: No change will be made to this feature. The current setting will remain. To select a setting, press the set/reset button while the desired setting is displayed on the DIC. Chime Volume This feature allows you to select the volume level of the chime. Press the customization button until Keyless Locking appears on the DIC display. Press the set/reset button once to access the settings for this feature. Then press the menu up/down button to scroll through the following settings: Off (default): The keyless locking feature will be disabled. On: The keyless locking feature will be enabled. The doors will automatically lock several seconds after you turn the ignition off, remove a keyless access transmitter from the interior of the vehicle, and close all of the doors. No Change: No change will be made to this feature. The current setting will remain. To select a setting, press the set/reset button while the desired setting is displayed on the DIC.