2010 Cadillac CTS Owner's Manual - Page 228

6-44 Infotainment System . 3. Say the entire number without pausing. . If the system recognizes the number, it responds with "OK, Dialing" and dials the number. If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say "Yes". The system responds with "OK, Dialing" and dials the number. If the number is not correct, say "No". The system will ask for the number to be re-entered. For vehicles with a navigation system, the system responds with a tone. After the tone say "Hands Free". The system responds with "Ready" followed by a tone. . To hear all of the numbers recognized by the system, say "Verify" at any time and the system will repeat them. Using the Call Command 1. Press and hold two seconds: . . b g for 2. Say "Digit Dial". The system responds with "Digit dial using , please say the first digit to dial" followed by a tone. 3. Say the digit to be dialed one at a time. Following each digit, the system will repeat back the digit it heard followed by a tone. 4. Continue entering digits until the number to be dialed is complete. After the whole number has been entered, say "Dial". The system responds with "OK, Dialing" and dials the number. . For vehicles without a navigation system, the system responds with "Ready" followed by a tone. For vehicles with a navigation system, the system responds with a tone. After the tone say "Hands Free". The system responds with "Ready" followed by a tone. . Using the Digit Dial Command 1. Press and hold two seconds: . b g for For vehicles without a navigation system, the system responds with "Ready" followed by a tone. If an unwanted number is recognized by the system, say "Clear" at any time to clear the last number. 2. Say "Call". The system responds with "Call using . Please say the name tag" followed by a tone.