2010 Cadillac CTS Owner's Manual - Page 231

Infotainment System To Transfer Audio to the In-Vehicle Bluetooth System The cellular phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the ignition is turned to the ON/RUN or ACC/ACCESSORY position. 1. During a call with the audio on the cell phone, press and hold b g for two seconds: . 6-47 Voice Pass-Thru Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturers user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone. 1. Press and hold two seconds: . 3. Say "Voice". The system responds with "OK, accessing ". . The cell phone's normal prompt messages will go through its cycle according to the phone's operating instructions. b g for Dual Tone Multi-Frequency (DTMF) Tones The in-vehicle Bluetooth system can send numbers and numbers stored as name tags during a call. This is used when calling a menu driven phone system. Account numbers can be programmed into the phonebook for retrieval during menu driven calls. Sending a number during a call 1. Press b g . The system responds with "Ready" followed by a tone. 2. Say "Dial". The system responds with "Say a number to send tones" followed by a tone. For vehicles without a navigation system, the call transfers to the Bluetooth system. For vehicles with a navigation system, the system responds with a tone. After the tone say "Hands Free". The call then transfers to the Bluetooth system. For vehicles without a navigation system, the system responds with "Ready" followed by a tone. For vehicles with a navigation system, the system responds with a tone. After the tone say "Hands Free". The system responds with "Ready" followed by a tone. . . 2. Say "Bluetooth". The system responds with "Bluetooth ready" followed by a tone.