2011 Cadillac DTS Owner's Manual - Page 170

The cruise control buttons are located on left side of the steering wheel. Setting Cruise Control If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used. The cruise light on the instrument panel cluster comes on after the cruise control has been set to the desired speed. 1. Press I. 2. Get up to the speed desired. 3. Press the SET- button located on the steering wheel and release it. I (On/Off): or off. Press to turn the cruise control system on 4. Take your foot off the accelerator. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed is 40 km/h (25 mph) or greater, press the +RES button on the steering wheel. The vehicle returns to the previously set speed and stays there. If you press and hold the +RES button, the vehicle speed increases until the button is released or the brake is applied. Do not hold in the +RES button, if you do not want the vehicle speed to increase. + RES (Resume/Accelerate): Press briefly to make the vehicle resume to a previously set speed or press and hold to accelerate. SET- (Set): Press to set the speed and activate cruise control or make the vehicle decelerate. [ (Cancel): Press to disengage cruise control without erasing the set speed from memory. 4-12