2011 Cadillac DTS Owner's Manual - Page 248

EQ (Equalization): For the non-Bose® amplified radio, perform the following steps to setup the equalization settings: 1. Press the displays. Adjusting the Speakers (Balance/Fade) BAL/FADE (Balance/Fade): To adjust balance or fade, press the a knob until the speaker control labels display. Continue pressing to highlight the desired label, or press the pushbutton positioned under the desired label. Turn the a knob to adjust the highlighted setting. The highlighted setting can be adjusted by pressing either SEEK arrow, \ FWD, or s REV buttons until the desired levels are obtained. To quickly adjust balance or fade to the middle position, press the pushbutton positioned under the BAL or FADE label for more than two seconds. A beep sounds and the level adjusts to the middle position. To quickly adjust all speaker and tone controls to the middle position, press the a knob for more than two seconds until a beep sounds. a knob until the equalization label 2. Press the pushbutton located under the equalization label to get choices of POP, ROCK, CTRY (country), TALK, JAZZ, and CLAS (classical), to display. 3. Press the pushbutton located under the desired setting. For the Bose amplified radio, perform the following steps to setup the equalization settings: 1. Press the a knob until the DSP label displays. 2. Press the pushbutton located under the DSP label to get choices of Norm, Driv, Rear, and Surround, to display. 3. Press the pushbutton located under the desired setting. To select Surround, press either the fourth or fifth pushbutton located under the displayed Surround until Centerpoint displays. To return to the manual mode, press the tune knob. Select either BASS, MID, or TREB and start to manually adjust the settings by turning the a knob. 4-90 Digital Signal Processing (DSP) This feature is used to provide a choice of four different listening experiences. DSP can be used while listening to the audio system or a CD. To change the DSP mode, press the a knob until the DSP control label displays. Press the pushbutton located under the DSP label until the control labels display. Continue by pressing the desired button below the control labels on the display.