2015 Cadillac ATS Owner Manual - Page 121

5-8 Instruments and Controls Always unplug electrical equipment when not in use and do not plug in equipment that exceeds the maximum 20 amps rating. indicator light turns off. To reset the circuit, unplug the item and plug it back in or turn the Retained Accessory Power (RAP) off and then back on. See Retained Accessory Power (RAP) on page 9-21. The power restarts when equipment using 150 watts or less is plugged into the outlet and a system fault is not detected. The power outlet is not designed for the following and may not work properly, if this equipment is plugged in: . to be replaced with a standard minifuse by the dealer. A minifuse will not reset and will have to be replace if blown. { Caution Failure to replace the circuit breaker with the minifuse could overheat the cigar lighter and damage the vehicle. When adding electrical equipment, be sure to follow the proper installation instructions included with the equipment. See Add-On Electrical Equipment on page 9-73. Power Outlet 110 Volt Alternating Current If equipped, this power outlet is on the rear of the center floor console. It can be used to plug in electrical equipment that uses a maximum limit of 150 watts. An indicator light on the outlet turns on to show it is in use. The light comes on when the ignition is in ON/RUN/START, equipment requiring less than 150 watts is plugged into the outlet, and no system fault is detected. The indicator light does not come on when the ignition is in LOCK/OFF or if the equipment is not fully seated into the outlet. If equipment is connected using more than 150 watts or a system fault is detected, a protection circuit shuts off the power supply and the { Caution Hanging heavy equipment from the power outlet can cause damage not covered by the vehicle warranty. The power outlets are designed for accessory power plugs only, such as cell phone charge cords. Equipment with high initial peak wattage such as: compressor-driven refrigerators and electric power tools. Other equipment requiring an extremely stable power supply such as: microcomputer-controlled electric blankets, touch sensor lamps, etc. Medical equipment. . .