2004 Chevrolet Venture Owner's Manual - Page 279

XM™ Radio Messages (cont'd) Radio Display Message Unknown Condition Radio ID not known (should only be if hardware failure) Hardware failure Action Required If you receive this message when you tune to channel 0, you may have a receiver fault. Consult with your dealer. If this message does not clear within a short period of time, your receiver may have a fault. Consult with your retail location. If an error appears on the display, see "CD Messages" later in this section. LOAD CD Z: Press the LOAD side of this button to load CDs into the CD player. This CD player will hold up to six CDs. To insert one CD, do the following: 1. Turn the ignition on. 2. Press and release the LOAD side of the LOAD CD button. 3. Wait for the light, located to the right of the slot, to turn green. 4. Load a CD. Insert the CD partway into the slot, label side up. The player will pull the CD in. Chk XMRcvr Playing a CD The CD player can play the smaller 8 cm single CDs with an adapter ring. Full-size CDs and the smaller CDs are loaded in the same manner. If playing a CD-R the sound quality may be reduced due to CD-R quality, the method of recording, the quality of the music that has been recorded, and the way the CD-R has been handled. You may experience an increase in skipping, difficulty in finding tracks, and/or difficulty in loading and ejecting. If these problems occur try a known good CD. Do not add paper labels to CDs, they could get caught in the CD player. Do not play 3 inch CDs without a standard adapter CD. 3-99