2007 Chevrolet Malibu Owner's Manual - Page 230
2007 Chevrolet Malibu Manual
Page 230 highlights
DISP (Display): Press this knob to switch the display between the time and the temperature or the radio station frequency and the temperature. When the ignition is off, press this knob to display the time. To change the default on the display, press the DISP knob until the desired option displays, then hold the knob for two seconds. The radio produces a beep and the selected display becomes the default. To scan preset stations, press and hold either SEEK button for more than four seconds until two beeps sound. The radio goes to the first preset station stored on the pushbuttons, plays for a few seconds, then goes to the next preset station. Press either SEEK button again to stop scanning presets. The radio only seeks and scans stations with a strong signal that are in the selected band. Finding a Station AM/FM/CD: Press this button to switch between FM1, FM2, AM, and CD. The selection displays. ADJ (Adjust): Turn this knob to select radio stations. SEEK w / SEEK x: Press the SEEK up button or the SEEK down button to go to the next or to the previous station and stay there. To scan stations, press and hold either SEEK button for two seconds until a beep sounds. The radio goes to a station, plays for a few seconds, then goes to the next station. Press either SEEK button again to stop scanning. 230 Setting Preset Stations Up to 18 stations (six FM1, six FM2, and six AM), can be programmed on the six numbered pushbuttons, by performing the following steps: 1. Turn the radio on. 2. Press AM/FM/CD to select FM1, FM2, or AM. 3. Tune in the desired station. 4. Press and hold one of the six numbered pushbuttons until a beep sounds. When that numbered pushbutton is pressed, the station that was set, returns. 5. Repeat the steps for each pushbutton.