2008 Chevrolet Impala Owner's Manual - Page 117
2008 Chevrolet Impala Manual
Page 117 highlights
Programming Universal Home Remote - Rolling Code If you have questions or need help programming the Universal Home Remote System, call 1-866-572-2728. Most garage door openers sold after 1996 are Rolling Code units. Programming a garage door opener involves time-sensitive actions, so read the entire procedure before you begin. If you do not follow these actions, the device will time out and you will have to repeat the procedure. To program up to three devices: 2. Locate in the garage, the garage door opener receiver (motor-head unit). Locate the "Learn" or "Smart" button. It can usually be found where the hanging antenna wire is attached to the motor-head unit and may be a colored button. Press this button. After you press this button, you will have 30 seconds to complete the following steps. 1. From inside the vehicle, press the two outside buttons at the same time for one to two seconds, and immediately release them. 3. Immediately return to your vehicle. Press and hold the Universal Home Remote button that you would like to use to control the garage door until the garage door moves. The indicator light, above the selected button, should slowly blink. You may need to hold the button from five to 20 seconds. 2-43