2011 Chevrolet Silverado 2500 HD Extended Cab Owner's Manual - Page 442
2011 Chevrolet Silverado 2500 HD Extended Cab Manual
Page 442 highlights
10-36 Vehicle Care out along the axle tubes and has not drained back to the sump area. Therefore, a reading taken five minutes after the vehicle has been driven will appear to have a lower fluid level than a vehicle that has been stationary for an hour or two. Remember that the rear axle assembly must be supported to get a true reading. What to Use Refer to Recommended Fluids and Lubricants on page 11‑8 to determine what kind of lubricant to use. Rear Axle When to Check Lubricant It is not necessary to regularly check rear axle fluid unless a leak is suspected or an unusual noise is heard. A fluid loss could indicate a problem. Have it inspected and repaired. All axle assemblies are filled by volume of fluid during production. They are not filled to reach a certain level. When checking the fluid level on any axle, variations in the readings can be caused by factory fill differences between the minimum and the maximum fluid volume. Also, if a vehicle has just been driven before checking the fluid level, it may appear lower than normal because fluid has traveled How to Check Lubricant All Other Series and Engines To get an accurate reading, the vehicle should be on a level surface. . 2500HD with 6.0 L For all 4.3 L, 4.8 L and 5.3 L 1500 Series applications, the proper level is 1.0 mm to 19.0 mm (0.04 in to 0.7 in) below the bottom of the fill hole, located on the rear axle. Add only enough fluid to reach the proper level.