2014 Chevrolet Traverse Owner Manual - Page 157
2014 Chevrolet Traverse Manual
Page 157 highlights
Instruments and Controls SERVICE TIRE MONITOR SYSTEM On vehicles with the Tire Pressure Monitor System (TPMS), this message displays if a part on the TPMS is not working properly. The tire pressure light also flashes and then remains on during the same ignition cycle. See Tire Pressure Light on page 5-22. Several conditions may cause this message to appear. See Tire Pressure Monitor Operation on page 10-46 for more information. If the warning comes on and stays on, there may be a problem with the TPMS. See your dealer. tire or sensor. See Tire Rotation on page 10-49, Tire Pressure Monitor System on page 10-45, and Tire Pressure on page 10-44 for more information. 5-41 message is reset. To reset the warning message manually, turn the ignition off and then back on again after 30 seconds. If the message stays on, see your dealer. See All-Wheel Drive on page 9-26. Transmission Messages ALL WHEEL DRIVE OFF If your vehicle has the All-Wheel Drive (AWD) system, this message displays when there is a temporary condition making the AWD system unavailable. The vehicle will run in 2WD. This could be caused by: . SERVICE ALL WHEEL DRIVE This message displays if a problem occurs with the All-Wheel Drive (AWD) system. The vehicle will run in 2WD. This could be caused by: . . An electronics problem Worn out or overheated clutch plates Various electrical issues A compact spare tire on the vehicle AWD system overheat Loss of wheel or vehicle speed Certain other vehicle electrical conditions . TIRE LEARNING ACTIVE This message displays when the Tire Pressure Monitor System (TPMS) is relearning the tire positions on your vehicle. The tire positions must be relearned after rotating the tires or after replacing a ... This message turns off when the compact spare tire is replaced by a full-size tire, the differential fluid cools or the above conditions are no longer present and the warning If this message appears, stop as soon as possible and turn off the ignition for 30 seconds. Restart the vehicle and check for the message on the DIC display. If the message still displays or appears again when you begin driving, the system needs service. See your dealer right away.