2008 Chrysler Pacifica Owner Manual - Page 148
2008 Chrysler Pacifica Manual
Page 148 highlights
148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE to HomeLink for more efficient training and accurate transmission of the radio-frequency signal. Your vehicle should be parked outside of the garage while training. 1. Turn the ignition switch to the ON/RUN position. 2. Place the hand-held transmitter 1-3 inches (3-8 cm) from the HomeLink buttons while keeping the indicator in view. For optimal training, point the battery end of the handheld transmitter away from the HomeLink. 3. Simultaneously press and hold both the chosen HomeLink button and the hand-held transmitter button until the until the red HomeLink indicator changes from a slow to a rapid flash rate or the EVIC display changes from "CHANNEL # TRAINING" to "CHANNEL # TRAINED." Then release both the HomeLink and hand-held transmitter buttons. If the EVIC display states "DID NOT TRAIN" repeat Step 3. If the signal is too weak, replace the battery in the original hand-held transmitter. It may take up to 30 seconds, or longer in rare cases. The garage door may open & close while you train. NOTE: Some gate operators and garage door openers may require you to replace Step #3 with procedures noted in the "Gate Operator/Canadian Programming" section. 4. Press and hold the newly-trained HomeLink button. If the channel has been trained, the EVIC display will now state "CHANNEL # TRANSMIT." If the EVIC display still states "CHANNEL # TRAINING" repeat Step 3.