2007 Dodge Caravan Owner's Manual - Page 181

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 181 Canadian Programming/Gate Programming Canadian radio-frequency laws require transmitter signals to time-out (or quit) after several seconds of transmission which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to time-out in the same manner. If you live in Canada or you are having difficulties programming a gate operator by using the Programming procedures (regardless of where you live), replace Programming HomeLink Step Three with the following: NOTE: If programming a garage door opener or gate operator, it is advised to unplug the device during the cycling process to prevent possible overheating. 3. Continue to press and hold the HomeLink button while you press and release every two seconds cycle your hand-held transmitter until the frequency signal has successfully been accepted by HomeLink. (The indicator light will flash slowly and then rapidly.) Proceed with Programming Step Four to complete. Using HomeLink To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties or questions, contact HomeLink at: www.homelink.com or 1-800-3553515. Erasing HomeLink Buttons To erase programming from the three buttons (individual buttons cannot be erased but can be reprogrammed note below), follow the step noted: 3