2008 Dodge Nitro Owner Manual - Page 198
2008 Dodge Nitro Manual
Page 198 highlights
198 INSTRUMENT PANEL AND CONTROLS Operating Instructions - Radio Mode NOTE: The ignition switch must be in the ON or ACC position to operate the radio. Power Switch/Volume Control (Rotary) Press the ON/VOL control to turn the radio ON. Press the ON/VOL a second time to turn OFF the radio. Electronic Volume Control The electronic volume control turns continuously (360 degrees) in either direction without stopping. Turning the volume control to the right increases the volume and to the left decreases it. When the audio system is turned on, the sound will be set at the same volume level as last played. SEEK Buttons (Radio Mode) Press and release the SEEK buttons to search for the next listenable station in AM/FM mode. Press the right switch to seek up and the left switch to seek down. The radio will remain tuned to the new station until you make another selection. Holding either button will bypass stations without stopping until you release it. SCAN Button (Radio Mode) Pressing the SCAN button causes the tuner to search for the next listenable station, in AM, FM or Satellite (if equipped) frequencies, pausing for 5 seconds at each listenable station before continuing to the next. To stop the search, press the SCAN button a second time. Voice Recognition Button (UConnect™ Hands Free Phone) - If Equipped Press this button to operate the Hand Free Phone (UConnect™) feature (if equipped). Refer to "Hands-Free Communication (UConnect™)" in Section 3 for more information. If your vehicle is not equipped with or this feature is not available on your vehicle, a "UConnect™ System Not Available" message will display on the radio screen.