2008 Dodge Ram 2500 Pickup Owner Manual - Page 405

STARTING AND OPERATING 403 Before Plowing • Check the hydraulic system for leaks and proper fluid level. • Check the mounting bolts and nuts for proper tightness. • Check the runners and cutting edge for excessive wear. The cutting edge should be 1/4 to 1/2 inch (6.4 mm to13 mm) above ground in snow plowing position. • Check that snowplow lighting is connected and functioning properly. Snowplow Model Prep Package Availability For Detailed Information Visit www.dodge.com or refer to the Current Dodge Truck Body Builders Guide. 1. The 1500 models are NOT available for snowplow applications. 2. The maximum number of occupants in the truck should not exceed two. 3. The total GVWR, or the Front GAWR, or the Rear GAWR should never be exceeded. 4. The snowplow prep packages are not available with the Sport Package. 5. Cargo capacity will be reduced by the addition of options or passengers, etc. The loaded vehicle weight, including the snowplow system, all aftermarket accessories, driver, passengers, options, and cargo, must not exceed either the Gross Vehicle Weight (GVWR) or Gross Axle Weight (GAWR) ratings. These weights are specified on the Safety Compliance Certification Label on the driver's side door opening. NOTE: Detach the snowplow when transporting passengers. Vehicle front end wheel alignment was set to specifications at the factory without consideration for the weight of the plow. Front end tow-in should be checked and reset if 5