2010 Dodge Grand Caravan Cargo Owner Manual - Page 234

UNDERSTANDING YOUR INSTRUMENT PANEL 233 damaged, a "noFUSE" message will display in the odom- cluster. To reset the oil change indicator system (after eter display area. For further information on fuses and performing the scheduled maintenance), refer to the fuse locations refer to "Fuses" in "Maintaining Your following procedure: Vehicle". 1. Turn the ignition switch to the ON position (Do not CHAngE OIL start the engine). Your vehicle is equipped with an engine oil change 2. Fully depress the accelerator pedal slowly three times indicator system. The "Change Oil" message will flash in within 10 seconds. the instrument cluster odometer for approximately 12 seconds after a single chime has sounded to indicate 3. Turn the ignition switch to the OFF/LOCK position. the next scheduled oil change interval. The engine oil NOTE: If the indicator message illuminates when you change indicator system is duty cycle-based, which start the vehicle, the oil change indicator system did not means the engine oil change interval may fluctuate reset. If necessary repeat this procedure. dependent upon your personal driving style. 13. Odometer / Trip Odometer Display Reset Button Unless reset, this message will continue to display each To reset a message display (gATE, gASCAP, noFUSE, time you turn the ignition switch to the ON/RUN CHAngE OIL, LoCOOL, LoWASH), push and hold the position. To turn off the message temporarily, press and button until the display resets (approximately two secrelease the Trip Odometer button on the instrument onds). 4