2002 Ford Expedition Owner Guide 1st Printing - Page 66

Lights Replacing front parking lamp/turn signal bulbs 1. Make sure that the headlamp control is in the OFF position. 2. Open the hood. 3. Remove the screw and lamp assembly from the vehicle. 4. Rotate the bulb socket counterclockwise and remove from the lamp assembly. 5. Carefully pull the bulb out of the socket and push in the new bulb. 6. Install the bulb socket into the lamp assembly and rotate clockwise. 7. Install parking lamp assembly on vehicle. 8. Push gently until parking lamp assembly seats. 9. Install screw on the lamp assembly. Replacing tail lamp/backup lamp bulbs The tail lamp/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Open the liftgate to expose the lamp assembly screws. 2. Remove the two screws from the lamp assembly. 3. Carefully pry the lamp assembly away from the vehicle to expose the bulb sockets. 4. Rotate the bulb socket counterclockwise and remove from lamp assembly. 5. Pull bulb straight out of socket and push in the new bulb. 6. Install the bulb socket into the lamp assembly and rotate clockwise. 7. Carefully install the tail lamp assembly on the vehicle snapping the three retaining tabs into place. 8. Secure the lamp assembly with two screws. 66