2002 Ford Expedition Owner Guide 1st Printing - Page 88

Driver controls If you do not successfully program the HomeLink௡ Universal Transceiver after repeated attempts, refer to Rolling code programing which follows, or call toll-free customer assistance: 1-800-355-3515 or on the Internet at HomeLink.jci.com. Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting after two seconds which may not be long enough to program the HomeLink௡ Universal Transceiver. To program your hand-held transmitters: • Continue to hold the button on the HomeLink௡ Universal Transceiver. • Press and re-press the hand-held transmitter button every two seconds until the red light changes from a slow to a fast flash. Operating the HomeLinkா Universal Transceiver Once programmed, the HomeLink௡ Universal Transceiver can be used in place of hand-held transmitters. To operate, simply press and release the appropriate HomeLink௡ button (the red light will illuminate, indicating the signal is being transmitted). Rolling code programming Rolling code garage door openers (or other rolling code devices) which are "code protected" and manufactured after 1996, may be determined by the following: • Reference the device owner's manual for verification • The hand-held transmitter appears to program the HomeLink௡ Universal Transceiver but does not activate the device. • Press and hold the trained HomeLink௡ button. The device has the rolling code feature if the indicator light flashes rapidly and then turns solid after two seconds. 88