2002 Ford Explorer Sport Owner Guide 6th Printing - Page 293
2002 Ford Explorer Sport Manual
Page 293 highlights
Maintenance and care 1. Install the new bulb in lamp assembly by pushing straight in and turning to lock in position. You may need to turn the bulb slightly to align the grooves in the plastic base with the tabs in the lamp assembly. 2. Connect the electrical connector to the bulb. 3. Install the headlamp on the vehicle by aligning the lamp on the vehicle, push rearward to fully seat the lamp assembly then push the two retainer pins down. 4. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aimed before you changed the bulb, you should not need to aim it again. Replacing front parking lamp/turn signal/sidemarker bulbs 1. Make sure headlamp switch is in OFF position, then open the hood. 2. Remove screw from the lamp assembly. 3. Disengage lamp assembly by pulling forward. 4. Rotate bulb socket counterclockwise and remove from lamp assembly. 5. Carefully pull bulb straight out of socket and push in the new bulb. 6. Install bulb socket in lamp assembly by turning clockwise. 7. Align the parking lamp studs with the plastic grommets on the vehicle and push rearward to snap in place. 8. Install screw on lamp assembly. 293