2010 Ford Ranger Regular Cab Owner Guide 2nd Printing - Page 177
2010 Ford Ranger Regular Cab Manual
Page 177 highlights
Driving To start the vehicle: 1. Make sure the parking brake is fully set. 2. Press and hold the clutch pedal to the floor, then put the gearshift lever in the neutral position. 3. Start the engine. 4. Press the brake pedal and move the gearshift lever to the desired gear; 1 (First) or R (Reverse). 5. Release the parking brake, then slowly release the clutch pedal while slowly pressing on the accelerator. During each shift, the clutch pedal must be fully pressed to the floor. Make sure the floor mat is properly positioned so it doesn't interfere with the full extension of the clutch pedal. Failure to fully press the clutch pedal to the floor may cause increased shift efforts, prematurely wear transmission components or damage the transmission. Do not drive with your foot resting on the clutch pedal or use the clutch pedal to hold your vehicle at a standstill while waiting on a hill. These actions will severely reduce the life of the clutch and could nullify a clutch warranty claim. Recommended shift speeds Upshift and downshift according to the following charts: Upshifts when accelerating (for best fuel economy) Transfer case position (if equipped) Shift from: 2H or 4H 4L 1-2 10 mph (14 km/h) 4 mph (5 km/h) 2-3 22 mph (32 km/h) 9 mph (11 km/h) 3-4 33 mph (50 km/h) 13 mph (19 km/h) 4 - 5 (Overdrive) 41 mph (71 km/h) 17 mph (27 km/h) 177