2011 Ford F450 Super Duty Crew Cab Diesel Supplement 5th Printing - Page 88

2011 Ford F450 Super Duty Crew Cab Manual

Page 88 highlights

Scheduled Maintenance Guide Operating in dusty conditions (i.e. unpaved or dusty roads) Every 7,500 miles (12,000 km) - Rotate tires, inspect tires for wear and measure tread depth and inspect wheel ends for endplay and noise; dual rear wheels should only be rotated if unusual wear is observed - Inspect steering and suspension ball joints and tie rods; lubricate if equipped with grease fittings - Inspect air filter restriction gauge; replace filter as indicated by gauge - Inspect brake system pads and rotors Every 7,500 miles (12,000 km), - Change engine oil and filter 6 months or 300 engine hours - Inspect and lubricate U-joints Every 15,000 miles (24,000 km), - Replace engine- and frame-mounted fuel filters 6 months, 600 engine hours or as indicated by message center Every 30,000 miles (48,000 km) - Replace wheel bearing grease/grease seals if nonsealed bearings are used (2WD vehicles) Reset your Intelligent Oil Life Monitor™ after each engine oil and filter change; refer to the Instrument Cluster chapter of the Owner's Guide. Use of Biodiesel, up to and including 20% Biodiesel (B20) As required - Change engine oil and filter as indicated by message center and perform services listed in the scheduled maintenance chart Every 15,000 miles (24,000 km), - Replace engine- and frame-mounted fuel filters 6 months, 600 engine hours or as indicated by message center 88 2011 Diesel (eco) Supplement, 5th Printing USA (fus)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95

Operating in dusty conditions (i.e. unpaved or dusty roads)
Every 7,500 miles (12,000 km)
– Rotate tires, inspect tires for wear and measure tread
depth and inspect wheel ends for endplay and noise; dual
rear wheels should only be rotated if unusual wear is
observed
– Inspect steering and suspension ball joints and tie rods;
lubricate if equipped with grease fittings
– Inspect air filter restriction gauge; replace filter as
indicated by gauge
– Inspect brake system pads and rotors
Every 7,500 miles (12,000 km),
6 months or 300 engine hours
– Change engine oil and filter
– Inspect and lubricate U-joints
Every 15,000 miles (24,000 km),
6 months, 600 engine hours or as
indicated by message center
– Replace engine- and frame-mounted fuel filters
Every 30,000 miles (48,000 km)
– Replace wheel bearing grease/grease seals if non-
sealed bearings are used (2WD vehicles)
Reset your Intelligent Oil Life Monitor™ after each engine oil and filter
change; refer to the
Instrument Cluster
chapter of the
Owner’s Guide.
Use of Biodiesel, up to and including 20% Biodiesel (B20)
As required
– Change engine oil and filter as indicated by message
center
and
perform
services
listed
in
the
scheduled
maintenance chart
Every 15,000 miles (24,000 km),
6 months, 600 engine hours or as
indicated by message center
– Replace engine- and frame-mounted fuel filters
Scheduled Maintenance Guide
88
2011 Diesel
(eco)
Supplement, 5th Printing
USA
(fus)