2012 Ford F150 F-150 Raptor Supplement 1st Printing - Page 30

30 Item Rear axle fluid friction modifier 4 oz. (118 ml) - - XT-10-QLV / MERCON௡ LV XL-12 / - Additive Friction Modifier Fuel tank Transmission fluid3 Transfer case lubricant 1 Maintenance 2012 F-150 (f12) Supplement, 1st Printing USA (fus) Capacity Ford part name or equivalent Ford part number / Ford Specification XL-3 EST-M2C118-A 26 gallons (98.4L) 12.4L (13.1 quarts) 4 1.4-1.5L (2.9-3.1 pints) Motorcraft MERCON௡ LV ATF Motorcraft Transfer Case Fluid Add the coolant type originally equipped in your vehicle. Fill 6 mm to 14 mm (1/4 inch to 9/16 inch) below bottom of fill hole. Your vehicle's rear axle is filled with a synthetic rear axle lubricant and is considered lubricated for life. These lubricants do not need to be checked or changed unless a leak is suspected, service is required or the axle assembly has been submerged in water. The axle lubricant should be changed any time the rear axle has been submerged in water. 3 Ensure the correct automatic transmission fluid is used. Transmission fluid requirements are indicated on the dipstick or on the dipstick handle. Check the container to verify the fluid being added is of the correct type. Refer to your scheduled maintenance information to determine the correct service interval. 4 Approximate dry fill capacity including transmission fluid cooling system, actual refill capacities will vary based on vehicle application and transmission fluid cooling system (i.e. coolers size, cooling lines, auxiliary cooler capacities). The amount of transmission fluid and fluid level should be set by the indication on the dipstick's normal operating range. 5 Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the requirements of Ford specification WSS-M2C945-A and the API Certification mark. 2