2006 GMC Yukon Owner's Manual - Page 14

Rear Seats Rear Seat Operation Entering or Exiting the Third Row Seats Regular Models If your vehicle has the 60/40 Split Bench seat in the second row, you must flip and fold the second row seat following the instructions later in this section. See 60/40 Split Bench Seat (Second Row) on page 1-10. To exit the third row seat with no assistance, do the following: 1. Reach over the second row seat and pull up on the strap loop located in the center of the seat where the seatback and the seat cushion meet. Then pull the seat cushion up and push it forward. {CAUTION: If the seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. Always push and pull on the seatback to be sure it is locked. Return the seat to the normal seating position when finished. Push and pull on the seatback to make sure it is locked in place. Extended Models The passenger's side of both the second row 60/40 split bench seat and the second row bucket seat has an easy entry/exit feature. This makes it easy to get in and out of the third row seat. 2. Next, push the seatback forward until it is flat with the floor. 1-8