2006 GMC Yukon Owner's Manual - Page 18

Returning the Seats to the Normal Seating Position To return the seat to the normal seating position, do the following: 1. On extended models, lift the load floor panels and latch them into the seatback. 4. Lower the seat cushion until it latches into position. Pull up on the seat cushion to make sure it is locked. {CAUTION: A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted. 5. Make sure that the safety belt buckles on the driver's side seat are accessible to the outboard and center occupants and are not under the seat cushions. {CAUTION: If the seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. Always push and pull on the seatback to be sure it is locked. 2. Lift the seatback up and push it rearward all the way. Push and pull on the seatback to make sure it is locked in place. 3. On regular models, return the headrests to the upright position. On extended models, return the headrests from the stored position to the seatback. 1-12