2011 GMC Canyon Regular Cab Owner's Manual - Page 162

7-12 Infotainment System To scan preset channels, press and hold q or r for more than four seconds, PSCN displays and the radio beeps once. The radio goes to a preset channel, plays for a few seconds, then goes to the next preset channel. Press q or r again, to stop scanning presets. Finding an XM Channel BAND: Press to switch between FM1, FM2, AM, or XM1 or XM2 (if equipped). The selection displays. DISPL (Display): Press to retrieve four different categories of information related to the current song or channel: Artist, Song Title, Category or PTY, Channel Number/Channel Name. XM Radio Messages XL (Explicit Language Channels): These channels, or any others, can be blocked at a customer's request, by calling 1-800-929-2100 in the U.S. and 1-877-438-9677 in Canada. Updating: The encryption code in the receiver is being updated, and no action is required. This process should take no longer than 30 seconds. No Signl: The system is functioning correctly, but the vehicle is in a location that is blocking the XM signal. When the vehicle is moved into an open area, the signal should return. Loading: The radio system is acquiring and processing audio and text data. No action is needed. This message should disappear shortly. Off Air: This channel is not currently in service. Tune to another channel. Setting Preset Channels If the radio has XM, up to 30 stations (6 FM1, 6 FM2, 6 AM, 6 XM1, and 6 XM2) can be programmed on the six numbered pushbuttons. To program either radio: 1. Tune in the desired channel. 2. Press and hold one of the six numbered pushbuttons until the radio beeps once. When that numbered pushbutton is pressed again, the channel that was stored, returns. 3. Repeat the steps for each pushbutton. q TUNE r : Turn to select XM Channels. q SEEK r : Press to go to the previous or next channel and stay there. Press and hold for more than two seconds, SCAN displays and the radio beeps once. The radio goes to a channel, plays for a few seconds, then goes to the next channel. Press q or r again, to stop scanning presets. q SCAN r :