2012 GMC Canyon Owner's Manual - Page 103

Seats and Restraints attach the top tether to the top tether anchor. Refer to the instructions that came with the child restraint and to Lower Anchors and Tethers for Children (LATCH System) on page 3‑41. and feed the shoulder belt back into the retractor. When installing a forward-facing child restraint, it may be helpful to use your knee to push down on the child restraint as you tighten the belt. Try to pull the belt out of the retractor to make sure the retractor is locked. If the retractor is not locked, repeat Steps 5 and 7. 8. Tighten the top tether. See Lower Anchors and Tethers for Children (LATCH System) on page 3‑41. 9. Before placing a child in the child restraint, make sure it is securely held in place. To check, grasp the child restraint at the safety belt path and attempt to move it side to side and back and forth. When the child restraint is properly installed, there should be no more than 2.5 cm (1 in) of movement. 3-59 If the vehicle is equipped with the passenger sensing system, and when the passenger sensing system has turned off the right front passenger frontal airbag, the off indicator on the passenger airbag status indicator should light and stay lit when you start the vehicle. See Passenger Airbag Status Indicator on page 5‑11. If a child restraint has been installed and on indicator is lit, see "If the On Indicator is Lit for a Child Restraint" under Passenger Sensing System on page 3‑26 for more information. To remove the child restraint, unbuckle the vehicle safety belt and let it return to the stowed position. 7. To tighten the belt, push down on the child restraint, pull the shoulder portion of the belt to tighten the lap portion of the belt,