2012 GMC Canyon Owner's Manual - Page 95

Seats and Restraints 3-51 Center Front Seat - Regular/ Extended Cab without Rear Seats For vehicles without rear seats, manufacturers are required to provide top tether anchors for all non-driver seating positions and instructions for using those anchors. Even if a top tether anchor is available, you should not install a child restraint in the center front seat position. See Where to Put the Restraint on page 3‑39 for important safety information and additional information on installing a child restraint in the center front seat position. See "Securing Child Restraints (Center Front Seat Position)" later in this section for instructions on installing the child restraint using the safety belts and top tether anchor. If the position you are using has an adjustable headrest or head restraint and you are using a single tether, raise the headrest or head restraint and route the tether under the headrest or head restraint and in between the headrest or head restraint posts. If the position you are using has a fixed or adjustable headrest or head restraint and you are using a dual tether, route the tether around the headrest or head restraint. 3. Attach and tighten the top tether according to your child restraint instructions. 4. Before placing a child in the child restraint, make sure it is securely held in place. To check, grasp the child restraint at the LATCH path and attempt to move it side to side and back and forth. There should be no more than 2.5 cm (1 in) of movement for proper installation.