2005 Honda Accord Owner's Manual - Page 154

HomeLink Universal Transceiver 4. Press and hold the remote transmitter button and one of the HomeLink buttons at the same time. While continuing to hold the HomeLink button, press and release the remote transmitter button every 2 seconds. If the red indicator in HomeLink begins to flash slowly at first, then rapidily, release both buttons, and go to step 5. If the red indicator in HomeLink continues to flash slowly (does not begin to flash rapidly), repeat steps 2 thru 4. 6. Push and hold the HomeLink button for a few seconds, then watch the red indicator on HomeLink. If the indicator stays on or flashes slowly, repeat steps 2 thru 5. If the indicator flashes rapidly for 2 seconds, then stays on, you have a rolling code system. Go to ''Training With a Rolling Code System'' (see page 156). Training With a Rolling Code System For security purposes, newer garage door opening systems use a ''rolling'' or variable code. Information from the remote control and the garage door opener are needed before HomeLink can operate the garage door opener. The ''Training HomeLink'' procedure trains HomeLink to the proper garage door opener code. The following procedure synchronizes HomeLink to the garage door opener so it sends and receives the correct codes. 5. Plug in the garage door opener motor, then test the HomeLink button by pushing it for about 1 second. If the button works, programming is complete. If the button does not work, go to step 6. 7. Repeat these steps to train the other two HomeLink buttons to operate any other compatible remotely-controlled devices around your home (lighting, automatic gate, security system, etc.). 156