2008 Honda Accord Owner's Manual - Page 231

Main Menu Table Of Contents HomeLink Universal Transceiver 4. Test the HomeLink button by pushing it for about 1 second. If the button works, programming is complete. If the button does not work go to step 5. 5. Push and hold the HomeLink button for a few seconds, then watch the red indicator on HomeLink. If the indicator stays on, press the HomeLink button again; the remotely controlled device should operate. If the indicator flashes rapidly for 2 seconds then stays on, you have a rolling code transmitter: go to ''Training with a Rolling Code System.'' 6. Repeat these steps to train the other two HomeLink buttons to operate any other compatible remotely controlled devices around your home (lighting, automatic gate, security system, etc.). Training With a Rolling Code System For security purposes, newer garage door opening systems use a ''rolling'' or variable code. Information from the remote control and the garage door opener is needed before HomeLink can operate the garage door opener. The ''Training HomeLink'' procedure trains HomeLink to the proper garage door opener code. The following procedure synchronizes HomeLink to the garage door opener so it sends and receives the correct codes. 1. Make sure you have properly completed the ''Training HomeLink'' procedure. 2. Find the ''learn'' button on your garage door opener unit. The location will vary, depending on the manufacturer. 228 2008 Accord Sedan