2014 Honda Odyssey 2014 Odyssey Owner's Manual - Page 327
2014 Honda Odyssey Manual
Page 327 highlights
uu HomeLink® Universal Transceiver * u Training HomeLink ■ Training a Button 1. Position the remote transmitter you wish to link 1 to 3 inches (3 - 8 cm) from the HomeLink button you want to program. 1 Training a Button Retraining a Button If you want to retrain a programmed button for a new device, you do not have to erase all button memory. You can replace the existing memory code using this procedure. 1. Press and hold the desired HomeLink button until the HomeLink indicator begins to blink. NO Standard transmitter Rolling code transmitter 2. Press and hold the desired HomeLink button and the button on the remote transmitter. Does the HomeLink indicator (LED) blink after 10 secs? YES NO 3. Press and hold the programmed HomeLink button for about a sec. Does the device (garage door opener) work? YES NO YES a. Press and hold the remote and the HomeLink button at the same time. Then, while continuing to hold the HomeLink button, press and release the button on the remote every 2 secs. Does the LED blink within 20 secs? Indicator remains on for about 25 secs. Indicator blinks rapidly for two secs, then remains on for about 23 secs. 326 Features 2. Continue to hold the HomeLink button and follow steps 1 - 3 under "Training a Button." 4. Press and hold the HomeLink button again. Training Complete HomeLink LED is on. HomeLink indicator blinks for 2 secs, then remains on. Erasing Codes To erase all the codes, press and hold the two outside buttons until the HomeLink indicator begins to blink (about 10 to 20 secs). You should erase all codes before selling the vehicle. If you have any problems, see the device's instructions, visit www.homelink.com, or call HomeLink at (800) 355-3515. 5. Press and hold the HomeLink button again. The remote-controlled device should operate. Training Complete a. The remote has a rolling code. Press the "learn" button on the remote-controlled device (e.g. garage door opener). b. Within 30 secs, press and hold the programmed HomeLink button for 2 secs.