2014 Honda Odyssey 2014 Odyssey Owner's Manual - Page 548

Emissions Testing Testing of Readiness Codes Your vehicle uses "readiness codes," as part of its onboard self diagnostic system. Some states refer to these codes during testing to see if your vehicle's emissions components are working properly. The codes may not be read if you go through the testing just after the battery has gone dead or been disconnected. To check if they are set, turn the ignition switch to ON (w *1, without starting the engine. The malfunction indicator lamp will come on for several seconds. If it then goes off, the readiness codes are set. If it blinks five times, the readiness codes are not set. If you are required to have your vehicle tested before the readiness codes are ready, prepare the vehicle for retesting by doing the following: 1. Fill the gas tank to approximately 3/4 full. 2. Park the vehicle and leave the engine off for six hours or more. 3. Make sure the ambient temperature is between 40°F and 95°F (4°C and 35°C). 4. Start the engine without touching the accelerator pedal, and let it idle for 20 seconds. 5. Keep the vehicle in (P . Increase the engine speed to 2,000 rpm, and hold it there until the temperature gauge rises to at least 1/4 of the scale (about three minutes). 6. Let the engine idle with your foot off the accelerator for 20 seconds. 1 Testing of Readiness Codes The readiness codes are erased when the battery is disconnected, and set again only after several days of driving under a variety of conditions. If a testing facility determines that the readiness codes are not set, you may be requested to return at a later date to complete the test. If the testing facility determines the readiness codes are still not set, see a dealer. Information *1: Models with the smart entry system have an ENGINE START/STOP button instead of an ignition switch. Continued 547