2008 Infiniti FX35 Owner's Manual - Page 293
2008 Infiniti FX35 Manual
Page 293 highlights
CAUTION Always connect positive (+) to positive (+) and negative (−) to body ground (for example, strut mounting bolt, etc. - not to the battery). Make sure the jumper cables do not touch moving parts in the engine compartment and that the cable clamps do not contact any other metal. SCE0450A VQ35DE engine WARNING Always follow the instructions below. Failure to do so could result in damage to the charging system and cause personal injury. 1. If the booster battery is in another veA A hicle k, position the two vehicles (k B and the jumped vehicle: k ) to bring their batteries into close proximity to each other. Do not allow the two vehicles to touch. 2. Apply parking brake. Move the selector lever to the P (Park) position. Switch off all unnecessary electrical systems (light, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). Cover the battery with an C old cloth k to reduce explosion hazard. 4. Connect jumper cables in the sequence 1 2 3 4 as illustrated (k → k → k → k ). 5. Start the engine of the booster vehicle A k and let it run for a few minutes. 6. Keep the engine speed of the booster A vehicle k at about 2,000 rpm, and B start the jumped vehicle k in the normal manner. CAUTION Do not keep the starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the key off and wait 3 to 4 seconds before trying again. In case of emergency 6-11