2005 Lincoln LS Owner Guide 2nd Printing - Page 112

Driver Controls The compass reading will remain fixed when significant levels of magnetic interference are experienced (such as steel bridges). The compass will return to normal operation upon leaving the magnetized area. If highly magnetized items (such as magnetic mount antennas) are placed very near the compass the display will change to "C". If a "C" is displayed, remove the source of magnetic interference and re-calibrate compass, refer to Compass calibration adjustment. Most geographic areas (zones) have a magnetic north compass point that varies slightly from the northerly direction on maps. A correct zone setting will eliminate this error. Refer to Compass zone adjustment. Compass zone adjustment 1. Determine which compass zone you are in by referring to the zone map. 3 2 1 15 2. Turn the ignition to the ON/RUN 4 14 position. 13 12 6 7 8 9 1011 5 3. With the compass display turned on, press and hold the COMP side of NW the control for no more than six seconds until the zone selection number appears in the mirror display window. If a "C" appears repeat this step. 4. Release the COMP side of the control, then press it down again. 5. Repeatedly press until your zone number is shown in the mirror display, then release. 6. The display will show all segments, then return to normal compass mode within ten seconds. Compass calibration adjustment Perform this adjustment in an open area free from steel structures and high voltage lines. COMP MIRROR 112 2005 Lincoln LS (dew) Owners Guide (post-2002-fmt) USA_English (fus)