2006 Lincoln Zephyr Owner Guide 3rd Printing - Page 42
2006 Lincoln Zephyr Manual
Page 42 highlights
Lights 6. Remove the bulb socket by rotating it counterclockwise, then pulling it straight out of the lamp assembly. 7. Discard the old bulb and install the new bulb into bulb socket. 8. Install the new bulb socket into the lamp assembly by aligning the indexing fingers, then rotate clockwise to locked position. 9. If required, position the flexible washer bottle filler neck back to its original position and connect the snap strap (Passenger side only). 10. If required, reinstall the AirTube to the air filter assembly. (Driver's side only). Replacing stop/tail/turn and side marker bulbs Your vehicle is equipped with a rear lamp that has a stop/tail/turn and side marker lamp module containing integral multiple light emitting diodes (LED). If one or more LEDs burn out, the complete lamp module has to be replaced. See your authorized dealer for the replacement LED module. Replacing rear turn signal bulbs 1. Make sure the headlamp switch is in the OFF position and open the trunk. 2. Lift out trunk floor carpeting panel to access a Luggage Scuff Plate (Hard Molding) shingles and a Trunk Side Panel (dark grey, soft wheelhouse side trim panel) at the lamp area. 3. Carefully pull/push the Trunk Side Panel (dark grey, soft wheelhouse side trim panel) outboard to expose the lamp assembly. The most effective point to grasp the Trunk Side Panel when pulling it out from the Luggage Scuff Plate is at it's bottom edge where that edge meets the exposed sheet metal of the trunk floor. 42 2006 Zephyr (378) Owners Guide (post-2002-fmt) USA (fus)