2006 Mazda RX-8 Owner's Manual - Page 134

RX-8_8U58-EA-05J_Edition1 Page134 Thursday, August 25 2005 4:54 PM Black plate (134,1) Driving Your Mazda Starting and Driving Starting the Engine NOTE CAUTION Don't try the starter for more than 10 seconds at a time. If the engine stalls or fails to start, wait 10 seconds before trying again. Otherwise, you may damage the starter and drain the battery. 6. After starting the engine, let it idle for about 10 seconds. NOTE l Engine-starting is controlled by the spark ignition system. This system meets all Canadian Interference-Causing Equipment Standard requirements regulating the impulse electrical field strength of radio noise. 1. Occupants should fasten their seat belts. 2. Make sure the parking brake is on. 3. Depress the brake pedal. 4. (Manual transmission) Depress the clutch pedal all the way and shift into neutral. Keep the clutch pedal depressed while cranking the engine. (Automatic transmission) Put the vehicle in park (P). If you must restart the engine while the vehicle is moving, shift into neutral (N). NOTE In extremely cold weather, below _18 °C (0 °F), or after the vehicle has not been driven in several days, let the engine warm up without operating the accelerator. Whether the engine is cold or warm, it should be started without use of the accelerator. To protect the engine, when the engine coolant temperature is low, the engine does not run at high speeds. The fuel supply will be cut at an rpm lower than the red zone. l l (Manual transmission) The starter will not operate if the clutch pedal is not depressed all the way. (Automatic transmission) The starter will not operate if the shift lever is not in P or N. 5. Turn the ignition switch to the START position and hold (up to 10 seconds at a time) until the engine starts. 5-4 Form No.8U58-EA-05J