2006 Mazda RX-8 Owner's Manual - Page 180

RX-8_8U58-EA-05J_Edition1 Page180 Thursday, August 25 2005 4:56 PM Black plate (180,1) Driving Your Mazda Warning/Indicator Lights and Beep Sounds qTCS/DSC Indicator Light í NOTE This indicator light stays on for a few seconds when the ignition switch is turned to the ON position. If the TCS or DSC is operating, the indicator light flashes. If the light stays on, the TCS or DSC may have a malfunction and they may not operate correctly. Take your vehicle to an Authorized Mazda Dealer. If the battery is disconnected or a fuse is replaced, the DSC will be inoperable. In this case, the DSC OFF indicator light flashes and the TCS/DSC indicator light illuminates. To make the DSC operable, do the following procedure with the battery connected. 1. Turn the ignition switch to the ON position. 2. Turn the steering clockwise fully, then turn it counterclockwise fully. 3. Make sure the DSC OFF indicator goes off. 4. Turn the ignition switch to the OFF position, then turn it to the ON position again. 5. Make sure the TCS/DSC indicator light goes off. If the TCS/DSC indicator light and the DSC OFF indicator light remain illuminated even after turning the ignition switch to the ON position, consult an Authorized Mazda Dealer. qDSC OFF Indicator Light í This indicator light stays on for a few seconds when the ignition switch is turned to the ON position. It also comes on when the DSC OFF switch is pressed and TCS/DSC is switched off (page 5-25). If the light stays on when the TCS/DSC is not switched off, take your vehicle to an Authorized Mazda Dealer. The dynamic stability control may have a malfunction. qCruise Main Indicator Light (Amber)/Cruise Set Indicator Light (Green) The indicator light has two colors. 5-50 í Some models. Form No.8U58-EA-05J