2008 Mazda RX-8 Owner's Manual - Page 75

Knowing Your Mazda Advanced Keyless Entry and Start System CAUTION When leaving the vehicle, make sure the ignition switch is turned to the LOCK position. NOTE l Operation Using Advanced Key Functions qKeyless Entry System This system uses the more traditional key buttons to remotely lock and unlock the doors and opens the trunk lid. It can also help you signal for attention. Press the buttons slowly and carefully. NOTE l l When turning the ignition switch to the LOCK position, the ignition switch has to be pushed in from the ACC position and turned. Without being pushed in, the ignition switch stops at the ACC position and the vehicle battery may be discharged if the ignition switch is left in the ACC position. When leaving the vehicle, make sure the ignition switch is turned to the LOCK position. If the vehicle is left with the ignition switch not in the LOCK position, a beep sound is heard and the indicator light flashes to notify the driver. Refer to Warning Beep (page 3-16). l l l l The keyless entry system is designed to operate up to about 2.5 m (8 ft) from the center of the vehicle, but this may vary due to local conditions. The system does not operate when the ignition switch is not in the LOCK position or the start knob is pushed in. With the start knob installed in the LOCK position, the system is fully operational. If the ignition switch is not in the LOCK position or the start knob is pushed in, the system does not operate. All doors cannot be locked by pressing the lock button while any door is open. The hazard warning lights will also not flash. If the transmitter does not operate when pressing a button or the operational range becomes too small, the battery may be dead. To install a new battery, refer to Maintenance (page 3-5). 3-13