1998 Mercury Grand Marquis Owner Guide 1st Printing - Page 41
1998 Mercury Grand Marquis Manual
Page 41 highlights
Controls and features Note to Canadian residents During programming, your hand-held transmitter may automatically stop transmitting after two seconds which may not be long enough to program the HomeLink Universal Transmitter. If you are programming from one of these hand-held transmitters: • continue to hold the control on the HomeLink Universal Transmitter • re-press the hand-held transmitter every two seconds You may have to repeat this function several times while programming. Operating the HomeLinkா Universal Transmitter Once programmed, the HomeLink Universal Transmitter can be used in place of hand-held transmitters. To operate, simply press the appropriate channel control on the transmitter (the red light will illuminate, indicating the signal is being transmitted). Training a rolling code system Rolling code systems (garage door openers which are "code protected") may be determined by the following: • The hand-held transmitter appears to program the HomeLink Universal Transmitter but does not activate the garage door. • The garage door opener was manufactured after 1995. Follow these steps to train a garage door with the rolling code feature: 1. Locate the training control on the garage door opener receiver. Refer to the garage door opener manual or call 1-800-355-3515 if there is difficulty locating the training control. 41