2008 Mercury Mountaineer Owner Guide 1st Printing - Page 113

Driver Controls 5. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) Note: There are 30 seconds in which to initiate Step 6. 6. Return to the vehicle and firmly press, hold for two seconds and release the HomeLink௡ button. Repeat the press/hold/release sequence again and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink௡ should now activate your rolling code equipped device. To program additional HomeLink௡ buttons begin with Step 1 in the "Programming" section. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Gate Operator & Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting - not allowing enough time for HomeLink௡ to accept the signal from the hand-held transmitter. After completing Step 1 outlined in the "Programming" section, replace Step 2 with the following: Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent overheating. • Continue to press and hold the HomeLink௡ button (note Step 2 in the "Programming" section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink௡. The indicator light will flash slowly and then rapidly after HomeLink௡ accepts the radio frequency signal. • Proceed with Step 3 in the "Programming" section. 113 2008 Mountaineer (mnt) Owners Guide (post-2002-fmt) USA (fus)