2008 Mercury Mountaineer Owner Guide 1st Printing - Page 142
2008 Mercury Mountaineer Manual
Page 142 highlights
Locks and Security Switching from two step to one step door unlocking Your vehicle comes with two step unlocking enabled. Unlocking can be switched between two step and one step door unlocking by pressing and and buttons simultaneously on the remote entry holding both the transmitter for approximately 4 seconds. The parklamps will flash twice to indicate that the vehicle has switched to one step unlocking. Repeat the procedure to switch back to two-step unlocking. Locking the doors/liftgate 1. Press and release to lock all the doors and liftgate. The lamps will flash. Note: If any door, the liftgate or the liftgate glass are not closed properly, the lamps will not flash. and release again within three seconds to confirm that all the 2. Press doors are closed and locked. Note: The doors will lock again, the horn will chirp and the lamps flash once. Note: If any door, the liftgate or the liftgate glass are not closed properly, the horn will make two quick chirps. Opening the liftgate window Press to unlatch the liftgate window. Car finder twice within three seconds. The horn will chirp and the turn Press lamps will flash. It is recommended that this method be used to locate your vehicle, rather than using the panic alarm. Sounding a panic alarm to activate the alarm. The horn will sound and the parklamps Press will flash for a maximum of 3 minutes. Press again or turn the ignition to the 3 (ON) position to deactivate, or wait for the alarm to timeout in 3 minutes. Note: The panic alarm will only operate when the ignition is in the 1 (OFF/LOCK) position . 142 2008 Mountaineer (mnt) Owners Guide (post-2002-fmt) USA (fus)