2000 Nissan Frontier Owner's Manual - Page 111
2000 Nissan Frontier Manual
Page 111 highlights
Clock set Depressing the CLOCK and the buttons together sets hours. Depressing the CLOCK and buttons together sets minutes. cally changes from stereo to monaural reception. Radio reception is affected by station signal strength, distance from radio transmitter, buildings, bridges, mountains and other external influences. Intermittent changes in reception quality normally are caused by these external influences. Using a cellular phone in or near the vehicle may influence radio reception quality. again continues the SEEK function. Once the highest broadcasting station is reached, the radio continues in the SEEK mode at the lowest broadcast station. SCAN tuning Push and hold the tuning button for more than 1.5 seconds. SCAN illuminates in the display window. SCAN tuning begins from low to high frequencies and stops at each broadcasting station for five seconds. Pushing the button again during this five second period stops SCAN tuning and the radio remains tuned to that station. Clock priority mode In this mode the clock is shown in the display. If any radio or cassette tape functions are activated, the radio (or cassette tape) display illuminates for 10 seconds then returns to the clock mode. NOTE: After clock adjustment, the radio is in the clock priority mode. TUNE buttons WARNING The radio should not be tuned while driving in order that full attention may be given to the driving operation. Use the and buttons for manual tuning. To move quickly through the channels, hold either of the tune buttons down for more than 1.5 seconds. SEEK tuning Push the tuning button for less than 1.5 seconds. SEEK tuning begins from low to high frequencies and stops at the next broadcasting station. Pushing the button Radio/Cassette tape priority mode In this mode, the radio station illuminates in the display during radio operation. During cassette tape operation, TAPE illuminates in the display. Selecting the desired band Push the button to change from AM to FM1 or FM2 reception. The FM stereo indicator, ST, illuminates during FM stereo reception. When the stereo broadcast signal is weak, the radio automati- Heater, air conditioner and audio systems 4-11