2011 Nissan Rogue Owner's Manual - Page 192
2011 Nissan Rogue Manual
Page 192 highlights
MUTE button: Push the Push the setting. button to mute the audio sound. button again to release the mute desired level, push the AUDIO button repeatedly until the normal mode display reappears. Otherwise, the normal mode display will automatically reappear after approximately 5 seconds. CLOCK button: Push the CLOCK button to turn on or off the CLOCK display. See "CLOCK" in the "2. Instruments and controls" section for the detailed clock adjustment operation. TUNE (Tuning): or for manual Push the TUNE button tuning. To move quickly through the stations, push and hold the TUNE button. SEEK tuning: or to tune from Push the SEEK button low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning: Push the SCAN button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. to Station memory operations: AUDIO button: Push the AUDIO button to change the selecting mode as follows. Radio operation Push the TUNE ( , ) or SEEK ( , ) button to adjust Bass and Treble to the desired level. Use the TUNE or SEEK button also to adjust Fade or Balance modes. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To turn the beep sound off or on, push the TUNE or SEEK button until the desired mode is displayed. This turns on or off the beep sound when audio buttons are pushed. To change the Speed Sensitive Volume (Spd Sen Vol) mode to OFF, LOW, MID or HIGH, push the TUNE or SEEK button until the desired mode is displayed. Once you have adjusted the sound quality to the Radio (FM/AM) band select: Pushing the FM·AM radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. 12 stations can be set for the FM band (6 each for FM1 and FM2), and 6 can be set for the AM band for easy access. 1. Choose the radio band using the radio band select button. 4-34 Center display, heater, air conditioner, audio, phone and voice recognition systems