2011 Nissan Rogue Owner's Manual - Page 217
2011 Nissan Rogue Manual
Page 217 highlights
Initialization When the ignition switch is placed in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. If the button is pushed before the initialization completes, the system will accept any command. The command given is picked up by the microphone, and voice feedback is given when the command is accepted. . If you need to hear the available commands for the current menu again, say "Help" and the system will repeat them. If a command is not recognized, the system announces, "Command not recognized. Please say again." Repeat the command in a clear voice. If you want to go back to the previous command, you can say "Go back" or "Correction" anytime the system is waiting for a response. You can cancel a command when the system is waiting for a response by saying, "Cancel" or "Quit." The system announces "Cancel" and ends the VR session. You can button for 5 also push and hold the seconds on the steering wheel at any time to cancel the VR session. Whenever the VR session is cancelled, a double beep is played to indicate you have exited the system. If you want to adjust the volume of the voice feedback, push the volume control switch (+ or −) on the steering wheel while being provided with feedback. You can also use the radio volume control knob. . In most cases you can interrupt the voice feedback to speak the next command by button on the steering pushing the wheel. To use the system faster, you may speak the second level commands with the main menu command on the main menu. For example, button and after the tone say, push the "Call Redial." Note: The combined command of Call and (a Name) cannot be used. . Operating tips To get the best performance out of the NISSAN Voice Recognition system, observe the following: . Keep the interior of the vehicle as quiet as possible. Close the windows to eliminate surrounding noises (traffic noises, vibration sounds, etc.), which may prevent the system from recognizing voice commands correctly. Wait until the tone sounds before speaking a command. Otherwise, the command will not be received properly. Start speaking a command within 5 seconds after the tone sounds. Speak in a natural voice without pausing between words. . . How to say numbers NISSAN Voice Recognition requires a certain way to speak numbers in voice commands. Refer to the rules and examples below. . Either "zero" or "oh" can be used for "0". Example: 1-800-662-6200 - "One eight oh oh six six two six two oh oh", or - "One eight zero zero six six two six two oh oh" . Words can be used for the first 4 digits places only. Example: 1-800-662-6200 - "One eight hundred six six two six two oh oh", - NOT "One eight hundred six six two sixty . . . . Giving voice command To operate NISSAN Voice Recognition, push button located on the and release the steering wheel. After the tone sounds, speak a command. . Center display, heater, air conditioner, audio, phone and voice recognition systems 4-59