2014 Nissan Pathfinder Owner's Manual - Page 172

EXTENDING ENGINE RUN TIME The remote start feature can be extended one time by performing the steps listed in "Remote starting the vehicle" in this section. Run time will be calculated as follows: ● The first 10 minute run time will start when the remote start function is performed. ● The second 10 minutes will start immediately when the remote start function is performed. For example, if the engine has been running for 5 minutes, and 10 minutes are added, the engine will run for a total of 15 minutes. A maximum of two remote starts, or a single start with an extension, are allowed between ignition cycles. The ignition switch must be cycled to the ON position and then back to the OFF position before the remote start procedure can be used again. CANCELING A REMOTE START To cancel a remote start, perform one of the following: ● Aim the Intelligent Key at the vehicle and until the parking lights press and hold turn off. ● Turn on the hazard warning flashers. ● Cycle the ignition switch ON and then OFF. ● The alarm sounds due to illegal entry into the vehicle. ● The ignition switch is pushed without an Intelligent Key in the vehicle. ● The ignition switch is pushed with an Intelligent Key in the vehicle but the brake pedal is not depressed. ● Two remote vehicle starts, or a single remote start with an extension, have already been used. ● The vehicle is not in P (Park). ● The Remote Start function has been switched to the OFF position in Vehicle Settings of the vehicle information display. For additional information, see "Vehicle information display" in the "Instruments and controls" section of this manual. The remote engine start may display a warning or indicator in the vehicle information display. For an explanation of the warning or indicator please see "Vehicle information display warning and indicators" in the "Instruments and controls" section. CONDITIONS THE REMOTE START WILL NOT WORK The remote start will not operate if any of the following conditions are present: ● The ignition switch is placed in the ON position. ● The hood is not securely closed. ● The hazard warning lights are on. remains ● The I-Key Indicator Light solid in the vehicle information display. Pre-driving checks and adjustments 3-21