2014 Nissan Sentra Navigation System Owner's Manual - Page 77

MAP SD-CARD ROUTE CALCULATION AND VISUAL GUIDANCE Symptom The message "Error" appears. In the automatic reroute calculation, the waypoint is not included. Route information is not displayed. Possible cause The SD-card is not recognized by the system. Possible solution Replace the map SD-card if you see any damage. A waypoint that you have already passed is not included in the auto- If you want to go to that waypoint again, you need to matic reroute calculation. add it back to the route. Route calculation has not yet been performed. The vehicle is not on the suggested route. Route guidance is cancelled. Set the destination and perform route calculation. Drive on the suggested route. Turn on route guidance. This is not a malfunction. The automatic reroute calculation (or detour calculation) suggests the same route as the one previously suggested. The suggested route is not displayed. Route calculations took priority conditions into consideration, but the same route was calculated. Roads near the destination cannot be calculated. The starting point and destination are too close. The starting point and destination are too far away. Reset the destination to a main or ordinary road, and recalculate the route. Set a more distant destination. Divide the trip by selecting one or two intermediate destinations, and perform route calculations multiple times. Adjust the location of the starting point or destination. An indirect route is suggested. If there are restrictions (such as one-way streets) on roads close to the starting point or destination, the system may suggest an indirect route. The system may suggest an indirect route because route calculation Reset the destination to a main or ordinary road, and does not take into consideration some areas such as narrow streets recalculate the route. (gray roads). The landmark information does not correspond to the actual information. The suggested route does not exactly connect to the starting point or destination. This may be caused by insufficient or incorrect data on the map SD-card. There is no data for route calculation closer to these locations. Updated information will be included in the next version of the map SD-card. Set the starting point and destination on a main road, and perform route calculation. Troubleshooting guide 7-5