2015 Nissan Murano Quick Reference Guide - Page 14

FIRST DRIVE FEATURES AUTOMATIC DRIVE POSITIONER (if so equipped)  Two positions for the driver's seat, steering column (if so equipped) and outside mirrors can be stored in the automatic drive positioner memory.  Follow this procedure to set the memory positions: •P  ush the Ignition Switch to the ON or ACC position. (The vehicle should be stopped while setting the memory.) •A  djust the driver's seat, steering column (if so equipped) and outside mirrors to the desired positions using the adjusting switches for each feature. •P  ush the SET switch and within 5 seconds push the memory switch (1 or 2). •T  he indicator light for the memory switch you select will illuminate for approximately 5 seconds, and a chime will sound when memory is stored. •T  he driver's seat, steering column (if so equipped) and outside mirror positions are now set to your preferences.  These memorized positions can also be linked to your NISSAN Intelligent Key®. For more information, refer to the "Pre-driving checks and adjustments (section 3)" of your Owner's Manual. REAR SEAT ADJUSTMENTS FOLDING DOWN THE REAR SEAT  To fold the seats flat, release the connector tongue of the rear center seat belt from the buckle then store the connector and seat belt tongues in the retractor base on the ceiling 1 .  Fold the seatback forward using either the pull strap 2 , located on the outside edge of the rear seat, or the release lever 3 in the cargo area.  To raise the seatback manually, lift up each seatback and push it to the upright position until it is latched.  To raise the seatback automatically (if so equipped), push and hold the power seatback switch located in the cargo area 4 or the corresponding seat switch on the lower side of the instrument panel 5 . 1 2 4 3 5 •  A beep sounds once and the seatback begins to move automatically. • A  beep sounds twice when the seatback is fully returned to the upright seating position. RECLINING THE REAR SEATS  Brace the back of the seat with your arm while pulling on the strap. The seatback will release quickly.  Pull the reclining strap 2 , and move the seatback to the desired angle.  Release the reclining strap after positioning the seat at the desired angle. For more information, refer to the "Safety - Seats, seat belts and supplemental restraint system (section 1)" of your Owner's Manual. 12 To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.