1997 Oldsmobile Silhouette Owner's Manual - Page 107

Resetting the Power Sliding Door The power sliding door may operate incorrectly or not all because of the following conditions: 0 7. Push either of the power door buttons to open the power sliding door. A low voltage or dead battery, Disconnecting the battery or If the IGN 1, B/U LAMP, RADIO or PWR SEAT/PSD fuse is removed or blown. 8. Wait five seconds and close the door by pushing either power door button. 9. Wait five seconds and repeat Steps 7 and 8. If the door does not rest in the fully open position after repeating Step 7, repeat Steps 7 and 8 again. If the door still does not operate correctly, see your retailer for service. See "Fuse Panel" in the Index for more information about your fuse panel. If any of these conditions occur, the power sliding door will need to be reset. To do this, follow the directions listed here. It will be easier if you read through them once before beginning this procedure. 1. Check to be sure the power sliding door is unlocked and securely closed. Sliding Door Security Lock Your Oldsmobile is equipped with a sliding door security lock that helps prevent young children or other passengers from opening the sliding door from the inside. This lock is on both doors if your vehicle has the dual sliding doors. I f you have the optional power sliding door, you can override the security lock by pressing either power door switch when the power sliding door override feature is disabled. See "Power Sliding Door" earlier in the section. 2 . Turn the ignition switch to the OFF position. 3. Enable the power sliding door override feature. 4. Remove the RADIO fuse from the underhood fuse and relay center. Leave it out for 30 seconds. 5 . Reinstall the fuse and wait 1 0 seconds. 6. Disable the power sliding door override feature. The security lock lever is located on the inside of the sliding door, on the front edge of the door. To access the lever, open the sliding door. Use the security lock label on the edge of the door as a guide.