2007 Saturn Aura Owner's Manual - Page 321
2007 Saturn Aura Manual
Page 321 highlights
See Engine Compartment Overview on page 308 for more information on location. 1. Remove the dipstick and wipe it with a clean rag or paper towel. 2. Reinstall it back in all the way, wait three seconds and then pull it back out again. How to Add Automatic Transaxle Fluid Refer to the Maintenance Schedule to determine what kind of transaxle fluid to use. See Recommended Fluids and Lubricants on page 415. If the fluid level is low, add only enough of the proper fluid to bring the level into the cross hatched area on the dipstick. 1. Remove the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It does not take much fluid, generally less than a half pint (0.24 L). Do not overfill. Notice: Use of the incorrect automatic transaxle fluid may damage your vehicle, and the damages may not be covered by your warranty. Always use the automatic transaxle fluid listed in Recommended Fluids and Lubricants on page 415. 3. After adding fluid, recheck the fluid level as described under "How to Check Automatic Transaxle Fluid," earlier in this section. 4. When the correct fluid level is obtained, reinstall the dipstick back in all the way. 321 3. Check both sides of the dipstick, and read the lower level. The fluid level must be within the cross hatched area. 4. If the fluid level is in the acceptable range, reinstall the dipstick back in all the way.