2003 Subaru Legacy Owner's Manual - Page 213

Audio B FM/AM selection button Press the "FM/AM" selection button 1 to choose either FM or AM broadcasts. The display will show FM or AM accordingly. Use the tuning dial to select the station to which you wish to listen. B Manual tuning Turn the tuning dial 3 outer tuner to increase or decrease the reception frequency in individual steps. FM band: 0.2 MHz steps AM band: 10 kHz steps B Seek tuning (SEEK) If the Tuning dial 3 outer tuner is turned for longer than half of a second, the radio will begin to automatically search for receivable frequencies and will stop at the first one found. This function may not be available, however, when radio signals are weak. In such a situation, perform manual tuning to select the desired station. B Scan tuning (SCAN) Press the "SCAN" button 4 to change the radio to the SCAN mode. In this mode, the radio scans through the radio band until a station is found. The radio will stop at the station for five seconds while displaying the frequency, after which scanning will continue until the entire band has been scanned. Turn the tuning dial 3 inner tuner again to cancel the SCAN mode and to stop on any displayed frequency. Scan tuning may not function properly if the station reception is weakened by distance from the station or proximity to tall buildings and hills. B Preset tuning Press any one of the preset buttons 5 to select the corresponding, previously-registered radio station. The LED at the top of that button will turn on. n Manual preset D Use the tuning dial 3 to select the radio station which you wish to register. - CONTINUED - 5 5-29